Machine Pin and E-Clip

Hardened steel piston (or plunger, also called a "ram") improves the action of old machines. Threaded end matches button plate and threaded dies. Appearance may vary from image depending on stock. An E-clip fastener (sometimes called a "lock ring" or "E-ring") is included with every pin. Fits the following machines:

Defiance No. 1920
Defiance No. 23 Foot Press
Dyna-Line No. 1920 (and probably Lip Lok)
Osborne W-1
Wade
Handy Jr. No. 1*** PLEASE READ BELOW
*** = If you want to continue using button dies, you MUST also purchase an Osborne plate. You will essentially be turning your Handy machine into an Osborne machine. Your machine will function exactly the same and you can switch the old pin back at any time.
*** = If you replace your Handy pin with an Osborne pin... we MUST decrease the diameter of screw-type die stems (grommet, snap, etc.) so that they will fit into your Handy base. PLEASE let us know in the "Comments" section at check-out that you have a Handy machine with an Osborne pin.